GMP Systems 

Cutting & Facing Tools

[Deburring Tools][Blades & Bits]

rabbit.jpg (62866 bytes)

Deburring Tools

Regardless of the technology, a burr will occasionally occur on a finished tube or pipe end. The cost of material and labor makes scrapping an unacceptable alternative. Inexpensive carbide hand deburring tools, when properly used, will remove unacceptable burrs without damaging the material or joint configuration.

Blades & Bits

Blades and bits for all of our preparation tools are stocked at our Pine Brook warehouse. Special blades and bits as well as beveling and chamfering items per application are stocked at factory warehouses and usually available from stock.

 

For questions or technical assistance contact our sales department by phone at (973) 575 - 4990, by fax at (973) 808 - 9201 or by email at sales@gmpsystems.com
Send mail to webmaster with questions or comments about this web site.
Copyright 1997 GMP Systems
Last modified: October 29, 1998